Hi all,
We have an SX1024 and compute nodes with Chelsio T520-CR.
On the nodes this is the output of ethtool:
[root@comp13 ~]# ethtool eth2
Settings for eth2:
Supported ports: [ ]
Supported link modes: 10000baseT/Full
Supported pause frame use: No
Supports auto-negotiation: No
Advertised link modes: Not reported
Advertised pause frame use: No
Advertised auto-negotiation: No
Speed: 10000Mb/s
Duplex: Full
Port: Direct Attach Copper
PHYAD: 255
Transceiver: external
Auto-negotiation: off
Supports Wake-on: bg
Wake-on: d
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
But when we try to ping hosts we get:
[root@comp13 ~]# ping -I eth2 172.20.1.17
PING 172.20.1.17 (172.20.1.17) from 172.20.1.16 eth2: 56(84) bytes of data.
From 172.20.1.16 icmp_seq=2 Destination Host Unreachable
From 172.20.1.16 icmp_seq=3 Destination Host Unreachable
From 172.20.1.16 icmp_seq=4 Destination Host Unreachable
From 172.20.1.16 icmp_seq=6 Destination Host Unreachable
From 172.20.1.16 icmp_seq=7 Destination Host Unreachable
From 172.20.1.16 icmp_seq=8 Destination Host Unreachable
^C
--- 172.20.1.17 ping statistics ---
8 packets transmitted, 0 received, +6 errors, 100% packet loss, time 7543ms
pipe 3
Does the switch require any license/firmware to be installed/updated? It's brand new and the web interface shows no errors..
Thanks,
Chrishas